2013 Land Rover Range Rover
Mileage
193,457
Service Date
12/11/2025
Services Performed
- SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – One Side
- Rear valve block
- Diag and once over
- Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
- Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center ste
- Install front park aid sensor
- BG Platinum Air intake and valve cleaning
- Remove and replace vacuum pump gaskets (4)
- Replace front brake pad linings and front brake disc rotors. Replace brake wear sensor. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Road test vehicle.
- Replace rear brake pad linings, rear brake disc rotors, and brake wear sensor. Clean and lubricate brake calipers and slide mechanisms. Check parking brake hard wear if applicable. Check and fill brake fluid. Bleed air from system. Road test vehicle.
- Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
- VALVE COVER GASKET – Remove & Replace – Normally Aspirated Both
- COOLANT CROSSOVER ASSEMBLY – Remove & Replace – Normally Aspirated
- ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Engine,Left
- ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Engine,Right Side
- ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Trans
- SPARK PLUGS – Remove & Replace
Chuck H. gave our service a 5 star review on 12/11/2025
